We research and compare products using published specifications, features and owner feedback. When you buy through our links, we may earn a commission. As an Amazon Associate I earn from qualifying purchases. Learn more›

How to Use Aqueon Algae Cleaning Magnet: Step-by-Step Guide

Learn how to use Aqueon algae cleaning magnet safely on glass and acrylic reef tanks, with setup steps, cleaning technique and common mistakes to avoid.

Updated November 2026

Knowing how to use Aqueon algae cleaning magnet correctly keeps your aquarium glass clear without scratching the surface or disturbing corals. This guide walks you through the setup, the cleaning technique and the habits that keep the tool working well. Follow the steps below and you can clean your tank in a few minutes without stirring up debris.

Before You Start: Check Your Tank Glass

A magnet cleaner is only safe on surfaces that stay clean of grit. Before you begin, confirm that the inside of the tank is free of sand, salt crystals and loose detritus, because any particle trapped between the pads and the glass can leave fine scratches. Glass tanks handle magnet cleaners well. Acrylic is softer, so check the pad type before using it there. For more on that, see Aqueon Algae Cleaning Magnet Replacement Pads Acrylic: A Practical Guide (2026).

Shopping for one? See our guide: 7 Best Algae Magnet Cleaners for Aquariums: Expert Picks Compared.

Step-by-Step: Using the Magnet Cleaner

  1. Rinse the magnet pad in tank water or saltwater of the same salinity. Freshwater can cause sudden salinity swings if you shake the pad back into the tank.
  2. Assemble the outer and inner magnets so the pad sits between them. Keep the pad on the inside of the glass and the magnet on the outside.
  3. Attach the inner magnet to the inside wall first, then slide the outer magnet onto the outside. Start at the top corner.
  4. Move the magnet in slow, overlapping horizontal passes, about one hand width at a time. Keep the pad flat against the glass.
  5. Lift the magnet at the end of each pass and reposition it. Never drag it diagonally or pull it sideways while the pad is still in contact with the glass.
  6. Remove the magnet from the tank and rinse the pad before storing it. Check the pad for any trapped sand or coral fragments.

Cleaning Frequency and Glass Coverage

Most reef keepers clean the front and sides of their tank once or twice a week, depending on light intensity and nutrient levels. Focus on the areas the eye sees most, usually the front glass and the upper section near the surface. Algae tends to build fastest where light and water movement meet, so spend extra time there.

Tools and Setup Checklist

  • Aqueon algae cleaning magnet with the inner and outer units
  • Replacement pad matched to your glass or acrylic
  • A small bucket of tank water for rinsing
  • A paper towel or soft cloth for wiping the outer glass

Common Mistakes

  • Cleaning with a dirty pad. Trapped sand will scratch the glass in one pass.
  • Pressing too hard. Firm pressure is unnecessary and can leave marks on softer acrylic.
  • Cleaning the sides and back of the tank in the same session as the front without rinsing the pad.
  • Letting the magnets slip apart mid-stroke, which can pull the inner magnet off the glass.
  • Ignoring a worn pad. Replace it when it loses its grip or starts to tear.

A spare replacement pad lets you swap in a clean one during cleaning, which reduces the risk of grit scratches. A soft-bristled brush can help clear the pad edges before storage. A small rinse container keeps the pad in tank water during the job.

  • Spare Aqueon algae magnet replacement pads, useful for keeping a clean pad on hand. View on Amazon
  • Soft-bristled aquarium brush for clearing pad edges. View on Amazon
  • Small plastic rinse bucket for tank water during cleaning. View on Amazon

FAQ

Can I use the Aqueon magnet on an acrylic reef tank?

Some Aqueon pads are designed for glass, and acrylic is softer and more easily scratched. Check the pad specifications and consider a pad made for acrylic before using it. Consult the tank manufacturer if you are unsure.

How often should I rinse the magnet pad?

Rinse the pad after each tank and before storing it, and again if you notice grit caught on the surface. A clean pad greatly reduces scratch risk.

Why does my magnet slip on the glass?

Slipping usually means the glass is dirty, the pad is worn, or the magnets are not aligned. Clean the glass edges, replace the pad if it is worn, and make sure both magnets sit squarely on either side of the wall.

Conclusion

Using the Aqueon algae cleaning magnet correctly comes down to a clean pad, slow overlapping passes and careful lifting at the end of each stroke. Clean the glass regularly and replace worn pads before they cause scratches. With these habits, your tank stays clear and your corals stay undisturbed.

Emily Parker

About Emily Parker

Emily Parker is part of our editorial team and reviews and edits our reef & saltwater aquariums guides, checking product details against manufacturer specifications and owner feedback.

About the author

Emily Parker
Emily Parker

Emily Parker writes reviews and buying guides for My Reef Aquarium.